Onkyo TX-SR506 - Manual (Page 66)

66
Adjusting the Listening Modes —Continued
On the Listening Mode Preset menu, you can specify a
default listening mode for each of the audio formats sup-
ported by each input selector. The AV receiver will then
select the listening mode automatically depending on the
format of the input signal. You can still select the other
listening modes, although the default listening mode will
be used the next time you turn on the AV receiver.
Note:
• This procedure can also be performed on the AV
receiver by using its [SETUP], [ENTER], and arrow
buttons.
Listening Mode Presets
(TX-SR576 only)
1 Press the [RECEIVER] REMOTE
MODE button, followed by the
[SETUP] button.
2 Use the Up and Down [ ]/[ ]
buttons to select “5.Listening-
Mode,” and then press [ENTER].
3 Use the Up and Down [ ]/[ ]
buttons to select an input selec-
tor, and then press [ENTER].
The audio formats supported by that
input selector appear.
For the TUNER input selector, Anlg
(Analog) is the only format available.
4 Use the Up and Down [ ]/[ ]
buttons to select an audio for-
mat, and use the Left and Right
[
]/[ ] buttons to select a lis-
tening mode.
Only listening modes compatible with
the audio format can be selected (see
pages 56–58).
A/PCM: Specifies the default listening
mode for analog and PCM sources.
Dolby: Specifies the default listening
mode for Dolby Digital sources.
DTS: Specifies the default listening
mode for DTS sources.
DF2ch: Specifies the default listening
mode for 2-channel (2/0) stereo sources
in a digital format, such as Dolby Digi-
tal or DTS.
Mono: Specifies the default listening
mode for mono sources in a digital for-
mat, such as Dolby Digital or DTS.
MCH P: Specifies the default listening
mode for multichannel PCM sources,
such as DVD-Audio (input via HDMI).
192k: Specifies the default listening
mode for high resolution 192kHz and
176.4kHz digital sources, such as
DVD-Audio.
5 When you’ve finished, press the
[SETUP] button.
Setup closes.