Onkyo TX-SR506 User Manual
Page 69
69
Advanced Setup
—Continued
Double Bass
With the Double Bass function, you can boost bass out-
put by feeding bass sounds from the front left, right, and
center to the subwoofer. This function can be set only if
the Subwoofer setting (step 3) is set to Yes, and the Front
setting (step 4) is set to Large in the Speaker Configura-
tion on page 67.
Note:
• These settings cannot be changed while headphones
are connected or the multichannel DVD input is being
used.
Speaker Distance
With these settings, you can specify the distance from
each speaker to the listening position.
11
Use the Down [
] button to
select “Double Bass (D.Bass),”
and then use the Left and Right
[
]/[
] buttons to select:
On:
Double Bass function on.
Bass from the front left and
right channels is also fed to
the subwoofer (default).
Off:
Double Bass function off.
12
Press the [SETUP] button.
Setup closes.
1
Measure and make a note of the
distance from each speaker to
the listening position.
This setting is not set automatically by the Automatic
Speaker Setup function (see page 36).
These settings are set automatically by the Automatic
Speaker Setup function (see page 36).
2
Press the [RECEIVER] REMOTE
MODE button, followed by the
[SETUP] button.
If you have a TX-SR506, proceed to
step 4.
3
(TX-SR576 only)
Use the Up and Down [
]/[
]
buttons to select “2.Speaker
Setup,” and then press the
[ENTER] button.
4
Use the Up and Down [
]/[
]
buttons to select “Sp Distance,”
and then press [ENTER].
5
While “Unit” is displayed, use the
Left and Right [
]/[
] buttons to
select “feet” or “meters”.
feet:
Distances can be set in feet.
Range: 1 to 30 feet in 1-foot
steps.
meters:
Distances can be set in
meters. Range: 0.3 to 9
meters in 0.3-meter steps.
6
Use the Down [
] button to
select “Front” (TX-SR506) or
“Left” (TX-SR576), and use the
Left and Right [
]/[
] buttons to
specify the distance for the front
speakers, then press the Down
[
] button to select the next
speaker.
7
Repeat step 6 for all speakers.
Note:
Speakers that you set to No or None in
the Speaker Configuration (page 67)
cannot be selected.