One for All URC-7781 - Manual (Page 31)

30
WWW.ONEFORALL.COM
Your ONE FOR ALL 12 Remote Control is compatible with ONE FOR ALL Light Control
accessories, allowing you to control one or more of the lights in your house using the
remote. To begin, you will need to purchase the ONE FOR ALL Light Control Starters Kit
(HC-8300). The next step is to set up a code which will allow you to control up to 10 Light
Control Receivers.
To setup a code, simply follow the normal procedure on page 6 and set up one
of the following codes as a Home Automation device (HOM).:
ONE FOR ALL Light Control – 2200, 2201, 2202, 2203, 2204, 2205, 2206, 2207,
2208, 2209, 2210, 2211, 2212, 2213, 2214, 2215
It is recommended to use the first code listed. As the Light Control system works with
Radio Frequency there is the possibility of interference. If your Light Control kit is not
responding well, try one of the other codes listed.
Set up the HC Receiver
To set up your HC Receiver to work with your remote, you will need to assign a number
to it. This is a one-time process that will allow you to control individual lights separately
if you purchase additional HC Receivers in the future. To assign a number to the plug,
follow these steps:
• Plug the lamp into the HC Receiver, and plug the HC Receiver into the wall
outlet. If your lamp has a power switch it should be in the “ON” position.
• Plug the Command Centre in as close as possible to the HC Receiver, so that
they are only 10-20 cm apart (the Command Centre can be moved after the
initial setup).
• Set up a HOM code (see page 6 how to set up a code) and make sure that
your remote control is in Light (HOM) Mode.
• Press the number you wish to assign to the HC Receiver. If this is your first Plug,
number 1 is recommended, number 2 for the second etc. The LED (underneath
the POWER key) should blink twice.
• Press and hold the button on the HC Receiver until the red light begins to
blink.
• Point your remote control towards the Command Centre and press the
Channel Up (+) key. The red light should stop flashing.
The remote should now operate the HC Receiver. To test it, check if the Channel
Up (+) and Channel Down (-) keys work to turn your light on and off respective-
ly, or if you have the HC8010 Dimmer unit, see if the Volume up key begins to
brighten or darken the light (press again to stop).
Once set up with the Starters Kit, the following keys will perform the following
functions on your ONE FOR ALL 12 Remote:
Key Name Function
Digit 1 Select Receiver 1
Digit 2 Select Receiver 2
Digit 3 Select Receiver 3
Digit 4 Select Receiver 4
Digit 5 Select Receiver 5
Digit 6 Select Receiver 6
Digit 7 Select Receiver 7
Digit 8 Select Receiver 8
Digit 9 Select Receiver 9
Digit 0 Select Receiver 10
Channel Up Turn Selected Receiver On
Channel Down Turn Selected Receiver Off
Volume Up Begin Dimming – Press Again To Stop*
Dimming feature is only available with the Light Control Dimmer unit (HC8010).
Extra Features
ONE FOR ALL Light Control
1
2
3
706159_7781_E_10t:12_Device_7780_Euro_10_Talen 18-07-2007 11:02 Pagina 30