Oregon Scientific EB833 - Manual (Page 14)

EN
14
6. Press [TIME] again to set and activate / deactivated
the alarm.
7. Press [+] or [-] to select between activation and
deactivation. The alarm icon will only appear when
the alarm is set.
8. Pressing [TIME] a last time to exit. The ALARM
indicator stops flashing.
NOTE If no buttons are pressed for 2 minutes during
setting sequence, the unit will return to Alarm Time
Display.
DEACTIVATING THE ALARM
When the alarm time is reached the alarm will sound for
1 minute.
To stop the alarm:
Pressing any button can stop the alarm sound.
COUNT-UP TIMER
The unit comes with a count-up timer and can count up
to 99 hours 59 minutes and 59 seconds.
To start, stop, and reset the timer:
1. Enter Timer Display.
2. Press [+] the timer starts counting.
3. Press [+] again, the timer stops. To start the timer
again without clearing the elapsed time, press [+].
4. To reset the timer to 0, press [+] to stop the timer and
then press [-].
TEMPERATURE DISPLAY
The current temperature is displayed in all three display
modes. The temperature can be displayed as Celsius
(°C) and Fahrenheit (°F).
To select the units of measure for the temperature
display:
1. Enter Date/Month Mode.
2. Press and hold [+] or [-] for about 2 seconds to
change the units of measure.
RESETTING THE UNIT
Located inside the battery compartment is a RESET
Button. Using a blunt object such as a paper clip, press
RESET to return all settings to the factory values.
The button is required only when the unit is not operating
in a favorable way, such as in the rare case of a
malfunction.
NOTE After resetting the unit all memories and data will
be cleared.
EB833(EN3) 8/31/04, 3:40 PM 14