Quatech QSP-100 - Manual (Page 21)

3.1 Command Line Options
The QSP-100 Client Driver for OS/2 supports two methods of configuration: using "system
assigned" resources and using "user assigned" resources. Both options provide full PCMCIA
compliance and functionality (including "Hot-swapping") but each has some advantages and
disadvantages as discussed in the following sections.
3.2 Configuring With "System Assigned" Resources
Allowing the OS/2 Plug-and-Play system to assign the hardware resources to the QSP-100 is the
ideal choice when only OS/2 programs will access the serial ports. When configuring the
hardware, the user simply specifies a list of COM port numbers. When a QSP-100 is inserted
into a PCMCIA socket, the client driver will configure the card as a series of COM ports, starting
with the lowest available port number in the list.
Configuring a QSP-100 with system assigned resources can be a problem, however, if DOS
and/or Windows applications will be accessing the serial ports. This is because most DOS appli-
cations write directly to the communications hardware and the Windows' Control Panel also
wants to know the hardware configuration of the serial ports. In these cases, the user may want
to configure the QSP-100 with "user assigned" resources.
1.1.1.1Example 1
DEVICE=C:\QSP-100\QSP100.SYS COM3
In example 1, the Client Driver will attempt to configure the QSP-100 as COM3 through COM6.
If COM3, 4, 5, or 6 already exists in the system, the QSP-100 will not be configured. Further-
more, only one QSP-100 can be installed in this system.
1.1.1.2Example 2
DEVICE=C:\QSP-100\QSP100.SYS COM7 COM3
In example 2, the Client Driver will attempt to configure the QSP-100 as COM3 through COM6.
If COM3, 4, 5, or 6 already exists in the system, the Client Driver will attempt to configure the
QSP-100 as COM7 through COM10. If COM7, 8, 9, or 10 already exist in the system, the
QSP-100 will not be configured. Up to two QSP-100s can be installed in this system.
QSP-100 Users Manual 18