Quest Diagnostics QUESTEMP 36 - Manual (Page 5)

9
PRINT
Allows printing to a parallel or serial printer or to a computer. The unit will
recognize the cable plugged in and configure itself for serial or parallel. If no
cable is plugged in it will default to serial. Press I/O ENTER to begin printing.
Press RUN STOP to return to the menu.
RESET
Allows clearing the logged data from memory. Press the I/O ENTER key to
enter the RESET mode. Clear the memory by holding down the I/O ENTER
key while the display counts down from three.
RUN
Begins a session in memory and logs the data. Begin a session by pressing the
RUN STOP key from either the menu or VIEW mode. An asterisk in the
lower right corner indicates the run mode. End the session by again pressing
the RUN STOP key or by holding down the I/O ENTER key while a
countdown is displayed in the lower right corner.
If the logging memory is full or if there are no sensors plugged into the unit,
attempting to enter the RUN mode will result in an error message. If the
memory fills while running, the asterisk in the lower left corner of the display
will turn into an “F” and the memory remaining screen will show “0.0”.
5. KEYPAD OPERATION
The unit operates using a membrane keypad with 4 keys. The I/O ENTER key
responds when the key is released while all other keys respond when the key is
pressed.
I/O ENTER
The unit turns on with a single key press. The unit turns off by holding the
key down while a countdown of 3-2-1 occurs in the lower right corner of
the display. This key is also used to select a mode or enter setup changes.
Pressing and releasing the key while viewing temperatures causes the
display to view the next available sensor bar (indicated in the upper right
corner of the display).
UP ARROW
Changes items appearing in the display. Scrolls up.
10
DOWN ARROW
Changes items appearing in the display. Scrolls down.
RUN STOP
From the menu or view modes, pressing this key starts or stops the run
mode. Pressing this key will exit the setup, print or reset modes.
6. DISPLAYED ITEMS
For the QUESTemp °36, the number in
the upper right corner indicates which
sensor bar’s data is displayed. 1
indicates the sensor bar placed on (or
attached to) the top of the instrument. Sensors 2 and 3 are labeled on the side of
the unit. W indicates the weighted average which only appears if a WBGT is
displayed and all three sensor bars are attached. An asterisk in the lower right
corner indicates that the unit is in the run mode and is logging data.
The following measurements can be accessed on the display:
Screen 1:
WET (WET BULB)
DRY (DRY BULB)
Screen 2:
GLOBE
Screen 3:
WBGTi (WBGT INDOORS)
WBGTo (WBGT OUTDOORS)
Screen 4:
RH (Relative Humidity)
H.I. or HU (Heat Index or Humidex)
Screen 5: AIR FLOW (If turned ON through setup)
Screen 6:
STAY TIME DATA
Screen 7:
TIME (24 hour format)
DATE
Screen 8:
BAT (Battery voltage)
MEM (Logging memory available in days)
WET 80.5°F ►1
DRY 92.2°F *