Quadra-Fire QV32EV-B User Manual

Page 20

Advertising
background image

Quadra-Fire • Village Collection Electric Fireplace • 4030-782 Rev D • 11/05

20

E. Maintenance Task List

D. Heater/Blower Assembly Maintenance

• Turn off the circuit breaker/unplug the heater before

servicing the heater/blower assembly.

• Allow heater to cool before removing.
• Open the lower grille panel to view the dashboard on the

heater (the lower grille may need to be removed).

• Remove the four outer screws. See Figure 10.2.
• Pull dashboard towards you to expose the light

compartment (the light tray does not need to be pulled all
of the way out of the heater).

• Reach into the back of the left rear corner of the light tray

and unplug wire harness from connector. To remove plug,
squeeze both sides and pull.

• Remove the hood by pulling it straight out.
• Remove the upper grille panel/door front by lifting it up

and out.

• Remove the four outer screws. See Figure 10.2.
• Pull the heater/blower assembly out of heater.
• Slide the heater/blower assembly back into the heater,

making sure that the wires do not touch the heater/blower
assembly housing.

•

Once the front of the heater/blower assembly is fl ush with
heater, reinstall the four screws removed earlier.

• Replace the upper grille panel and hood.
• Plug the wire harness back into the connector in the back

of the left rear corner of the light tray.

•

Slide dashboard back into heater and make sure all wires
are inside heater.

• Reinstall the four screws removed earlier.
• Turn on the circuit breaker or plug the heater back into

the wall outlet.

Remove
Outer
Screws

Figure 10.2 Installing Heater/Blower Assembly

Inspect

Maintenance Tasks

Circulation Compartment

1. Remove any foreign objects.

2. Verify unobstructed air circulation.

Advertising
This manual is related to the following products: