Framing and clearances, Warning, Danger – Quadra-Fire QV32EV-B User Manual

Page 7

Advertising
background image

Quadra-Fire • Village Collection Electric Fireplace • 4030-782 Rev D • 11/05

7

3

Framing and Clearances

A. Selecting Heater Location

Several options are available to you when choosing a loca-
tion for your heater. This heater may be used as a room
divider, installed along a wall, across a corner or used in an
exterior chase. See Figure 3.1. This heater may be installed
directly on the fl oor, carpet or raised on a hearth.

Fire Risk

Provide adequate clearances.
• Around air openings
• To

combustibles

• For

service

access.

Locate heater away from traffi c areas.

WARNING

B. Clearances

Figure 3.1 shows all clearances that must be maintained
around the heater.

Fire Risk

Due to high temperature, this

heater

should

be located out of high traffi c areas.
• Keep

combustible

materials

such

as

furniture, pillows, bedding, papers,
clothes and curtains at least 12 in.
(305 mm) from the front of the

heater

.

WARNING

Electrocution Risk
NEVER locate this

heater

where it may fall

into a bathtub or other water container.

• Contact local building administrator for

information on bathroom intallations.

DANGER

Fire Risk!

• Prevent

contact

with

sagging,

loose

insulation.

• Do NOT install against vapor barriers or

exposed insulation.

WARNING

Do NOT use this

heater

if any part has been under water.

Immediately call a qualifi ed service technician to inspect
the

heater

and to replace any part of the control system

which has been under water.

WARNING

1 in.

(26 mm) min.

14 in.

(356 mm)

14 in.

(356 mm)

36-1/4 in.

(921 mm)

45 in.

(1143 mm)

22-1/2 in.

(572 mm)

31-7/8 in.

(810 mm)

36-1/4 in.
(921mm)

36-1/4 in.

(921 mm)

Figure 3.1

Heater Locations

Fire Risk
• Comply with all minimum clearances to

combustibles as specifi ed.

Failure to comply may cause fi re.

WARNING

Note: Minimum and maximum clearances must be
maintained at all times. Illustrations throughout these
instructions refl ect typical installations and are for design
purposes only. Actual installation may vary slightly due to
individual design preferences.

The illustrations and diagrams used throughout these
installation instructions are not drawn to scale.

Advertising
This manual is related to the following products: