Toshiba D-R400 - Manual (Page 40)

40 EN 40 EN
TIMER RECORDING
Hints for Timer Recording
PROG. A
PROG. B
actual
recording
PROG. A PROG. B
When the starting time is the same:
A program set previously (PROG. A) has priority.
The first 2 minutes (at the longest) will be cut off.
PROG. A
PROG. B
actual
recording
PROG. A PROG. A PROG. C PROG. B
PROG. C
When the starting time and the ending time
for each programs are different:
A program that has earlier start time has priority.
The first 2 minutes (at the longest) will be cut off.
PROG. A
PROG. B
actual
recording
PROG.B PROG.A
When the recording time is partially overlapped:
PROG. A will start after PROG. B is complete to
be recorded.
The first 2 minutes (at the longest) will be cut off.
PROG. A
PROG. B
actual
recording
PROG. B
When the recording time is entirely overlapped:
PROG.A will not be recorded.
This unit records the programs according to priority if the timer programmings are overlapped. The timer
programming set previously has priority.
A timer recording of lower priority will be canceled or start from the middle.
Check the overlapped timer programmings and change the priority if necessary.
• If there is a power failure or this unit has been unplugged for more than 30 seconds, the clock setting and all timer
programming will be lost.
• If a disc is not inserted, flashes and timer recording cannot be performed. In some cases, will appear
momentarily around the start point as the unit attempts to record. Please insert a recordable disc.
• When all the timer recording is completed, flashes. To play back or eject the recorded disc, press
[I/ y ON/STANDBY] first, then select the recorded title and press [PLAY B], or [OPEN/CLOSE A] to remove the disc.
• During timer recording or timer standby mode ( will appear), any operations on the unit will not be available. To make
these operations available, press [STOP
C] on the front panel to cancel the timer recording or [I/y ON/STANDBY] to
release timer standby mode ( will disappear).
• To cancel the timer standby mode, press [I/ y ON/STANDBY].
• When the starting and the ending time are the same, the length of the recording will be set for 24 hours. When the
disc becomes full during the recording, the unit turns itself off.
• When the programmed starting and ending time are earlier than the current time, the setting will not be accepted
and be cleared for redoing.
• If the starting time is earlier and the ending time is later than the current time, the recording will start right after you
turn the power off.
The Priority of Overlapped Settings
Note for DVD recording
• When the recording time of 2 programs are overlapped, or
the end time of a program and the start time of another
program is the same, the first 2 minutes (at the longest) of
the subsequent program will be cut off.
• If the cut-off portion comes up to 3 minutes or more, this
program will be displayed with error number E40 in the
timer programming list.
PROG. A
PROG. B
actual
recording
The first 2 minutes (at the longest) will be cut off.
PROG. B PROG. A
When the end time of the programming
currently being recorded and the start time
of the subsequent program are same:
The beginning of the PROG. B may be cut off.
E7E7AUD_EN.indb 40 E7E7AUD_EN.indb 40 2007/01/31 11:55:50 2007/01/31 11:55:50