Toshiba D-R400 - Manual (Page 44)

44 EN 44 EN
SATELLITE LINK
5 Press [ENTER].
“To Standby Mode” is highlighted.
6 Press [ENTER] again.
Satellite Link
Start Mode
12:00 AM XP
To Standby Mode
In a second, the unit will be turned off
automatically as it goes into the satellite link
standby mode.
To cancel the satellite link function while in
the satellite link standby mode:
Press [I/
y y ON/STANDBY] to turn on the unit.
To cancel the satellite link function while the
satellite link recording is in progress:
Press [STOP
C] on the front panel of the unit.
Note
• If the signal of external input breaks up over 5 seconds, satellite link function will be canceled.
• If you have not set the clock, “Clock Setting” menu will appear at step 1. Follow to step 3 in “CLOCK SETTING” on
page 25.
• You cannot set the end time for the satellite link timer recording on this unit.
• Recording picture will be distorted if the copy protection signal is being detected during satellite link timer
recording.
• You can record the satellite link by using S-video input jacks on the rear panel. Refer to page 41 for more
information.
• Press [TIMER PROG.] during the satellite link timer recording to check the satellite link timer recording in
progress.
• When a regular timer recording and the satellite link timer recording are overlapped, those recordings are
recorded as illustrated below.
example 2
actual
recording
timer
recording
satellite link
example 3
actual
recording
timer
recording
satellite link
The first 2 minutes (at the longest) will be cut off.
example 1
timer
recording
actual
recording
satellite link
The first 2 minutes (at the longest) will be cut off.