Tascam FW-1884 - Manual (Page 24)

Page 24 of 35
V1.20 Driver Release Notes
Installing the V 1.20 Driver
Please refer to the V1.10 installation instructions on pages 15 & 16 of this document.
Installing V1.20 is the same. It is not necessary to install V1.10 before installing V1.20.
It is possible to install V1.20 over previous V1.00 and V1.10 installs.
What’s New
SoftLCD
· Added support for FE­8’s to the SoftLCD application. Now SoftLCD can display
data from both the FW­1884 and FE­8’s. (FE­8/SoftLCD support is required in
the control plug­in to use this feature.)
· Full support for Unicode added to the Sonar plug­in to support alternate language
based text.
· Added support for full message data dumps to SoftLCD to accommodate the
Logic Audio plug­in.
SONAR Plug­in V 1.20
Minimum requirement is the latest Sonar 3 patches. This is compatible with Sonar 4.
· Added support in the Sonar Plug­in for SoftLCD and the FE­8.
· Added Support for the track Select buttons in Sonar 3. Now pressing a track
Select button will highlight that track and place it into the Track Inspector
window.
· Added support for the new Sonitus channel EQ’s in Sonar 3. Now the EQ section
will automatically control any currently selected track or buss.
o SHIFT + CTRL+ any Band button ­ toggle the selected track/bus EQ on or
off
o SHIFT + Band button ­ toggle that band on or off
o CTRL+ Band button ­ select the type of filter for that band
o Gain, Freq, and Q encoders ­ operate normally based on type of filter
selected