Using the fw­1884 with tascam gigastudio (gsif) – Tascam FW-1884 User Manual

Page 9

Advertising
background image

Page 9 of 35 

Using the FW­1884 with TASCAM GigaStudio (GSIF) 

The Windows driver for the FW­1884 implements the GSIF (Giga Streaming Interface) 
protocol, for high­performance operation with TASCAM GigaStudio software. The GSIF 
driver is installed automatically with the FW­1884 driver; there is no need for a separate 
installation step. 

The FW­1884’s GSIF interface always operates at full 24­bit resolution, although 
GigaStudio has settings which can dither output to lower resolutions in special situations. 

To use the FW­1884 as your GigaStudio output device, make sure the FW­1884 is 
plugged in and turned on, and then start GigaStudio. When the main screen appears, 
select the Settings | Hardware/Routing page. Use the drop­down combo box labeled 
“Hardware” to select the FW­1884. If you will also be using the FW­1884’s MIDI Inputs 
to connect a keyboard or other controller, you should select the FW­1884’s MIDI Input 
ports in the drop­down boxes labeled “Midi In Ports.” 

IMPORTANT: Be sure to click the “Apply” button to activate changes you 
have made in this screen! 

All eighteen output channels of the FW­1884 may be utilized with GigaStudio. Since 
GigaStudio allows individual pairs of channels to be enabled via its Settings | 
Hardware/Routing page, it’s easy to control the number of active channels that 
GigaStudio is using. Channels that aren’t selected for use in GigaStudio are available to 
other applications via MME/WDM or ASIO since the FW­1884 is a true Multi­Client 
device. 

Here is a chart that shows the association of GigaStudio channel numbers 
with FW­1884 outputs: 

Giga 

FW­1884 

­­­­­­­­­­­­­­­­­­­­­­­­­­­­ 
1,2 

Analog 1:2 

3,4 

Analog 3:4 

5,6 

Analog 5:6 

7,8 

Analog 7:8 

9,10 

ADAT 1:2 

11,12 

ADAT 3:4 

13,15 

ADAT 5:6 

15,16 

ADAT 7:8 

17,18 

SPDIF 1:2

Advertising