TOA Electronics N-CC2360 - Manual (Page 11)

11
F.ADJ
ANTI-FLICKER
NC
OFF ON
Mode switch
Focus adjustment switch
Flicker-reduction switch
Not used.
Mode switch (factory default)
[ N-CC2360 ]
F.ADJ
ANTI-FLICKER
NC
ON OFF
INITIALIZE
RESET
OFF ON
OFF ON
OFF ON
OFF ON
9. ABOUT THE MODE SWITCH
Set each switch to the position that provides the best picture reproduction.
• Focus adjustment switch
Set this switch when adjusting the focus of a lens. (This setting provides the same effect as when using an
ND filter.)
Normal:
After focus adjustment completion, turn the switch to "OFF" position. Normally, use
this mode.
Adjustment (At the time of Adjustment):
Set the switch when focusing the lens. The object that was brought into focus in
bright locations could be out of focus in dark conditions. In such cases, turn the
Focus adjustment switch to "ON" position only when adjusting focus.
Note
When the Focus adjustment switch is set to the "ON" position, the color of the
screen may change periodically if the camera is used under fluorescent lighting.
Further, the screen may flicker in areas where the electrical frequency is 50 Hz.
• Flicker-reduction switch
Set the switch when flicker is annoying.
Normal:
Normally, use this mode.
Flicker-reduction:
Flickering of the picture may interfere with the view under fluorescent lamps in the
area where the electrical frequency is 50 Hz (CU) or 60 Hz (PL). In such cases, set
the Flicker-reduction switch to "ON" position, and the image free from flickering can
be obtained.
Note
Setting the Flicker-reduction switch to "ON" makes the sensitivity lower than when
set to "OFF." Set to the "OFF" position when flicker is not annoying or when the
camera is used in locations with poor lighting conditions.
9. ABOUT THE MODE SWITCH
Set each switch to the position that provides the best picture reproduction.
9. ABOUT THE MODE SWITCH
Set each switch to the position that provides the best picture reproduction.