TOA Electronics N-CC2360 - Manual (Page 5)

5
(1) Power Input Terminal [24 V AC, 24 V DC]
Connect this terminal to the 24 V AC or 24 V DC
power supply.
Note Do not connect 24 V AC or 24 V DC power
when using a PoE-compatible hub.
(2) Indicators [RDY BUSY ERR]
RDY (green): Remains lit during normal operation.
BUSY (yellow): Lights continuously during
communications.
ERR (red): Lights when an error occurs.
(3) Network Terminal [10BASE-T, 100BASE-TX]
Connect this terminal to a network.
• LINK/ACT indicator:
Lights when the network is correctly connected
and flashes while data is being transmitted or
received.
• FD/COL indicator:
Lights continuously while the camera is opera-
ting in full-duplex mode, and remains unlit
while the camera is in half-duplex mode.
The indicator flashes when a data collision
occurs over the network.
(4) Audio Output Terminal (RCA pin jack)
Outputs audio signals received via a network.
(5) Monitor Output Terminal (RCA pin jack)
Connect a monitor to this terminal.
(6) Contact Input/Output Terminal
• Contact input terminal:
Used to receive alarm signals from sensors,
etc. Setting the terminal to a Day-Night function
places the camera in monochrome mode.
• Contact output terminal:
Connect external equipment to this terminal for
its control.
(7) Back Focal Length Adjustment Ring Fixing
Screw
Used to fix the back focal length adjustment
ring.
(8) Camera Mount
(9) Initialization Key
Returns camera settings to initial factory-preset
status.
(10) Reset Key
Restarts the camera.
(11) Lens Connector
Connect the connector of the lens to this
connector.
(12) Mode Setting Switch
Changes camera settings.
(13) Back Focal Length Adjustment Ring
(14) Microphone
13 14
11
1
3
4
6
7
8
9 10
5
2
12
[ Top panel ]
[ N-CC2360 Rear panel ] [ Side panel ] [ Front panel ]
F.ADJ
ANTI-FLICKER
NC
ON OFF
INITIALIZE
RESET
24V
24V 2 1
1 2 C 1 2 C
10/100M AUDIO
OUT
MONITOR
OUT
OUT IN
CONTACT RDY BUSY ERR
FD/COL LINK
/ACT
5. NOMENCLATURE