Set-up, Set-up items – Technicolor - Thomson LDK 4502 User Manual
Page 36
3-4
User's Guide LDK 4502 - HDTV Camera Base Station
Operating Instructions
Set-up
Set-up items
There are four items that can be accessed via the set-up
Rotary/Push button on the Data Board:
•
Camera number (CA)
•
Subcarrier adjustment (SC)
•
H-phase (HP)
•
System menu (NN)
Remove the left front cover to access the Rotary/Push button
on the Data Board.
Rotate the button to the left or right to select the required item.
The display shows the abbreviation of the current item.
Camera Number (CA)
When CA is displayed, push the Rotary/Push button to enter
the selection mode. Rotate the button to the left or right to
select an available camera number. Push the Rotary/Push
button to set the new camera number. The Base Station
automatically resets and the new camera number is shown in
the display.
Subcarrier (SC)
When SC is displayed, push the Rotary/Push button to enter
the Subcarrier adjustment mode. Rotate the button to the left
or right to shift the Subcarrier phase. If you continue to rotate
Camera Base Station
Prod
Prog
Cam +Floor
Eng
HDTV
Camera Base Station
Display
Rotary / Push button
Left front cover
the button, the shift change occurs in bigger steps. Push the
Rotary/Push button to leave the Subcarrier adjustment mode.
H-Phase (HP)
When HP is displayed, push the Rotary/Push button to enter
the H-Phase adjustment mode. Rotate the button to the left
or right to shift the H-Phase. If you continue to rotate the
button, the shift change occurs in bigger steps. Push the
Rotary/Push button to leave the H-Phase adjustment mode.
System Menu (NN)
When NN is displayed, push the Rotary/Push button twice to
enter the System Menu. The Rotary/Push button can be used
to navigate through the menu system, however, it is more
convenient to use the OCP connected to the Base Station.
(Refer to the OCP user guide to find out how to do this.)
The System Menu video signal is available on the Text output
of the base station. The System Menu text can also be
superimposed on the CVBS and the Monitor output if desired.
Opening clasp