Tiger Products Co., Ltd JD 72-7520 - Manual (Page 29)

Assembly Section 2-5
ASSEMBLY
CABLE SWITCH BOX WIRING
Refer to the parts section for wiring diagram to hook up the switch box. Cover all
the wires from the switch box with plastic wire wrap provided. Route the wires from
the switch box to the front console panel as shown on previous page. Remove the
console panel under the steering wheel to access tractor wires. Locate the blue
colored wire. Using a test light or meter to verify this wire is the neutral safety
wire. Cut the blue wire and connect the green wires from the switch box as
shown in the wiring diagram.
To run the white wire to the solenoid valve, you will need to drill a hole in the front
edge of the cab floor on the right side of the front console. Insert a rubber grommet
into the hole to protect the wire, and route the wire out of the cab.
The red wire is to be hooked to the tractor ignition switch or an available slot in the
fuse box. NOTE: +12 VOLTS ELECTRICAL POWER MUST BE TAKEN FROM
A SOURCE LOCATION WHERE IT IS LIVE ONLY WHEN THE IGNITION
SWITCH IS IN THE “ON” POSITION. THIS WIRE MUST BE FUSED AT THE
SOURCE LOCATION
The travel lock red wire from the switch box should also run with the white wire
through the rubber grommet and be covered with wire wrap. This wire will be
connected to the electronic travel lock located on the main boom cylinder. The wires
from the switch box are longer than needed and should be carefully cut and
spliced as required. Zip ties should be used to secure the wires to the tractor
framework and boom hoses to eliminate vibation and rubbing.
Cut slot in right side panel of steering column to run wires from switch box.
NOTE: When cutting or drilling hole, be sure not to damage existing wires running
behind panels.