Tiger Products Co., Ltd JD 72-7520 - Manual (Page 38)

Assembly Section 2-14
ASSEMBLY
GENERAL HOSE INSTALLATION
Refer to the parts section for detailed information about hoses and fittings for this
application.
When mounting the suction hose between the pump and the tank, the stainless
steel bands that are provided must be used. CAUTION: DO NOT use regular hose
clamps for this purpose.
For protection of hoses in contact with metal edges, wrap hoses with spit hose
sections and fasten with hose clamps or zip ties as needed.
HOSE COVERING
Secure hoses together with zip ties wherever loose. Wrap the hoses between
the main boom and secondary boom with the new hose cover, secure with string
provided. Where hoses may contact the frame or other edges, wrap with split
hose and secure with hose clamps or zip ties. On non cab units the pressure and
return hoses from the control valve will also need to be routed inside the protective
clear hose wrap. Cover the valve, valve fittings with the new hose cover and
secure with string provided.
COOLER MOUNTING
Refer to the parts section for location of stand, brackets and hardware. The
cooler stand is mounted to the fenders and upper cab, using hardware as shown in
the parts section. Unbolt the upper rear cab lights and leave lights hang by the
wires, DO NOT CUT THE WIRES. Assemble mounting brackets to the cooler
stand as shown. Raise the cooler stand into positlion and reinstall bolts in cab light
mounting holes. Fully open and close rear cab window to insure clearance
between stand and window. Use the bracket as a template to mark location of
holes in fender. Drill 3/8” holes and install stand with the hardware as noted in
parts section. Reinstall rear lights to the mounting brackets. Remove the two
capscrews from each side of the cooler. Mount the cooler between the brackets
on the cooler stand using the pre-existing hardware removed from the cooler.
Install fittings and run hoses to locations as noted.