Texas Instruments TI-84 - Manual (Page 103)

Chapter 3: Function Graphing 100
Turning On or Turning Off a Stat Plot in the Y= Editor Turning On or Turning Off a Stat Plot in the Y= Editor Turning On or Turning Off a Stat Plot in the Y= Editor Turning On or Turning Off a Stat Plot in the Y= Editor
To view and change the on/off status of a stat plot in the Y= editor, use Plot1 Plot2 Plot3
(the top line of the Y= editor). When a plot is on, its name is highlighted on this line.
To change the on/off status of a stat plot from the Y= editor, press
} and ~ to place the
cursor on Plot1 , Plot2 , or Plot3 , and then press
Í.
Selecting and Deselecting Functions from the Home Screen or a Selecting and Deselecting Functions from the Home Screen or a Selecting and Deselecting Functions from the Home Screen or a Selecting and Deselecting Functions from the Home Screen or a
Program Program Program Program
To select or deselect a function from the home screen or a program, begin on a blank
line and follow these steps.
1. Press
 ~ to display the
VARS Y-VARS menu.
2. Select 4:On/Off to display the ON/OFF secondary menu.
3. Select 1:FnOn to turn on one or more functions or 2:FnOff to turn off one or more
functions. The instruction you select is copied to the cursor location.
4. Enter the number (1 through 9, or 0; not the variable Yn ) of each function you want to
turn on or turn off.
• If you enter two or more numbers, separate them with commas.
Plot1 is turned on.
Plot2 and Plot3 are turned off.