Texas Instruments TI-84 - Manual (Page 23)

Chapter 1: Operating the TI-84 Plus Silver Edition 20
To display the mode settings, press
z. The current settings are highlighted. Defaults
are highlighted below. The following pages describe the mode settings in detail.
Changing Mode Settings Changing Mode Settings Changing Mode Settings Changing Mode Settings
To change mode settings, follow these steps.
1. Press
† or } to move the cursor to the line of the setting that you want to change.
2. Press
~ or | to move the cursor to the setting you want.
3. Press
Í.
Normal Sci Eng Numeric notation
Float 0123456789 Number of decimal places
Radian Degree Unit of angle measure
Func Par Pol Seq Type of graphing
Connected Dot Whether to connect graph points
Sequential Simul Whether to plot simultaneously
Real a+b i re^
q
i Real, rectangular complex, or polar complex
Full Horiz G-T Full screen, two split-screen modes
Set Clock 01/01/01 12:00 AM