Teac CD-RW900CD - Manual (Page 15)

TASCAM CD-RW900
15
4−Playback operations
The CD-RW900 can be used to play back CDs (includ-
ing CD-R and CD-RW discs that have been recorded
and finalized on other types of recorder), as well as
CD-R discs and CD-RW discs that have been recorded
on the unit. Audio files in MP3 format on CD-ROM, CD-R and CD-
RW are also playable on the unit.
Discs for playback
The CD discs in the CD-RW900 can play back the
types of discs listed below.
≠ Commercial pre-recorded CDs recorded in CD-DA
format.
≠ CD-R and CD-RW discs that have been recorded
in CD-DA format and finalized properly.
≠ MP3 files recorded in ISO9660 level 1 and level 2
format on CD-R and CD-RW discs, and properly
finalized. MP3 files recorded in the format which
adheres to Joliet, are also playable.
1 Press the POWER switch to turn on the unit.
2 Press the OPEN/CLOSE key to open the disc tray.
The display shows Open. Insert a disc in the tray
with the label side up.
3 Press the OPEN/CLOSE key to close the tray. The
display shows Close when a disc is loaded into the
unit, then TOC Reading. will appear, with the period
flashing.
When the TOC has been read, the display shows the
number of tracks and total running time of the disc.
The CD-RW900 also shows one of the following:
TOC
A disc finalized
MP3 A disc contains MP3 files
4 Press the PLAY key to start playback.
Adjust the connected monitor system, or the level
control for the PHONES on the unit to set the listen-
ing level you desire.
WARNING
If you monitoring using headphones, adjust the level
control to low on the unit, then connect to the
PHONES
jack before playing back. This will prevent any possible
damage for your hearing.
5 To stop playback, press the STOP key.
Temporarily stop playback and enter playback
standby mode, press the READY key. To resume
playback, press the PLAY key again.
NOTE
The explanation in this manual will assume the user is
starting from the normal Continuous mode.
Simple playback operations
Track selection
Skipping track numbers backward or forward.
1 Select desired tracks for playback with the MULTI
JOG dial on the front panel. Turning clockwise skips
the track number backward and counterclockwise
skips forward.
Or, press the SKIP key on the remote control.
Pressing ¯ key skips the track number backward
and  key skips forward.
2 Press the PLAY key to start playback.
Or, press the READY key to cue the track and enter
playback standby mode after moving to the head
of the selected track. To start playback, press the
PLAY key.
Using the skip function
Disc type
Total running time Total number of tracks