Teac CD-RW900CD - Manual (Page 27)

TASCAM CD-RW900
27
Erasing tracks
This operation erases the specified track and all sub-
sequent tracks from a recorded CD-RW disc.
1 During stop, press the ERASE/DEL key on the front
panel or the ERASE key on the remote control. Se-
lect the ERASE TRACK? rotating the MULTI JOG
dial or pressing the SKIP keys on the remote con-
trol.
To cancel the operation at this point, press the
ERASE/DELor the ERASE key again.
2 Push the MULTI JOG dial or press the ENTER key
to enter the function.
The display shows Erase XX-XX (the number of the
first track and last track to be erased).
Rotate the MULTI JOG dial or press the SKIP key to
change the track numbers you desire to erase.
To cancel the operation at this point, press the
ERASE/DELor the ERASE key again.
3 Push the MULTI JOG dial or press the ENTER key
to operate the function.
The display shows Sure?
To cancel the operation at this point, press the
STOP key.
4 Push the MULTI JOG dial or press the ENTER key
again to proceed the operation.
The display shows the Erase flashing and the re-
maining time. The unit starts counting down from a
time shown on the display.
NOTE
Once the operation is proceeded, the STOP key cannot
function. Please confirm before the operation.
5 When the tracks have been erased, Complete will
appears on the display.
Erasing a whole disc
When you want to erase a whole disc (all the tracks on
a disc), follow the procedure below:
1 During stop, press the ERASE/DEL key on the front
panel or the ERASE key on the remote control. Se-
lect the ERASE DISC? rotating the MULTI JOG dial
or pressing the SKIP keys on the remote control.
To cancel the operation at this point, press the
ERASE/DEL or the ERASE key again.
2 Push the MULTI JOG dial or press the ENTER key
to enter the function.
The display shows Sure?.
To cancel the operation at this point, press the
STOP key.
3 Push the MULTI JOG dial or press the ENTER key
again to proceed the operation.
The display shows the Erase flashing and the re-
maining time. The unit starts counting down from a
time shown on the display.
NOTE
Once the operation is proceeded, the STOP key cannot
function. Please confirm before the operation.
4 When the disc has been erased, Complete appears
then Blank Disc will appear on the display.
Refreshing a disc
Refreshing the disc makes a disc usable again. This op-
eration destroys all data on the disc.
1 Load the disc, and the unit in stop mode, press the
ERASE/DEL key on the front panel or the ERASE
key on the remote control. Select the REFRESH?
rotating the MULTI JOG dial or pressing the SKIP
keys on the remote control.
To cancel the operation at this point, press the
ERASE/DEL or the ERASE key again.
2 Push the MULTI JOG dial or press the ENTER key
on the remote control to enter the function.
The display shows Sure?
To cancel the operation at this point, press the
STOP key.
3 Push the MULTI JOG dial or press the ENTER key
again to proceed the operation.
The display shows the Erase flashing and the re-
maining time. The unit starts counting down from a
time shown on the display.
4 When the disc has been refreshed, Complete will
appear on the display, and Blank disc shows up.
6-After recording
Erasing