Transition Networks E-100BTX-FX-05 - Manual (Page 2)

2
E-100BTX-FX-05
24-hour Technical Support: 1-800-260-1312 -- International: 00-1-952-941-7600
The media converters with the “HT” extension in the part number can be used in an
extended temperature environment from -25°C to 65°C (-13°F to 149°F).
Part Number Description
SPS-1872-SA Optional External Power Supply; 18-72VDC Stand-Alone Wide-Input;
Output: 12.6VDC, 1.0 A
SPS-1872-CC Optional External Power Supply; 18-72VDC Piggy-Back Wide-Input;
Output: 12.6VDC, 1.0 A
E-MCR-04 12-Slot Media Converter Rack (includes universal internal power supply)
17 x 15 x 5 in. (432 x 381 x 127 mm)
WMBL Optional Wall Mount Brackets; 4.0 in. (102 mm)
WMBV Optional Vertical Mount Bracket; 5.0 in. (127 mm)
WMBD Optional DIN Rail Mount Bracket; 5.0 in. (127 mm)
WMBD-FS Optional DIN Rail Mount Bracket (flat, small); 3.1in. (79 mm)
Part Number Port One - Copper
100Base-TX Port Two - Duplex Fiber-
100Base-FX
E-100BTX-FX-05(HT) RJ-45
100 m (328 ft)* ST, 1300 nm multimode
2 km (1.2 miles)*
E-100BTX-FX-05(SCHT) RJ-45
100 m (328 ft)* SC, 1300 nm multimode
2 km (1.2 miles)*
E-100BTX-FX-05(SMHT) RJ-45
100 m (328 ft)* SC, 1310 nm single mode
20 km (12.4 miles)*
E-100BTX-FX-05(LHHT) RJ-45
100 m (328 ft)* SC, 1310 nm single mode
40 km (24.9 miles)*
E-100BTX-FX-05(XLHT) RJ-45
100 m (328 ft)* SC, 1310 nm single mode
60 km (37.3 miles)*
E-100BTX-FX-05(LWHT) RJ-45
100 m (328 ft)* SC, 1550 nm single mode
80 km (49.7 miles)*
E-100BTX-FX-05(100HT)** RJ-45
100 m (328 ft)* SC, 1310Tx/1550Rx nm single
mode
20 km (12.4 miles)*
E-100BTX-FX-05(101HT)** RJ-45
100 m (328 ft)* SC, 1550Tx/1310Rx nm single
mode
20 km (12.4 miles)*
Accessories sold separately
**E-100BTX-FX-05(100/101HT) are installed in pairs.
[email protected] -- Click the “Transition Now” link for a live Web chat. 3
Installation
CAUTION: Wear a grounding device and observe electrostatic discharge
precautions when setting the 4-position switch and jumper. Failure to observe this
caution could result in damage or failure of the media converter.
4-position switch
• The 4-position switch is
located on the side of the
media converter. Use a small
flat-blade screwdriver or a
similar device to set the
recessed switches.
1. Auto-Negotiation
up Enables Auto-
Negotiation for the copper connection.
down Disables Auto-Negotiation for the copper connection.
2. Pause Control
up Enabled
down Disabled
3. Link Pass-Through
up Enabled
down Disabled
4. Far-End Fault
up Enabled
down Disabled
Link Pass-Through (up=Enable)
Pause (up=Enable)
Auto-Negotiation (up=Enable)
Far End Fault
(up=Enable)
1 2 3 4