Telit Wireless Solutions GE863 - Manual (Page 32)

GE863-GPS Software User Guide
1vv0300724 Rev. 2 - 24/01/07
SIM.
+CME ERROR: 17 PIN2 is required to continue
operations, since FD facility is
not enabled. Enable FD facility with +CLCK
(see par.3.1.1.2)
and retry.
NOTE: After power up & PIN authentication the device reads all the SIM for a backup, hence
SIM access is inhibited (SIM is busy after the issue of the PIN or after power up if PIN request
is disabled) for a time varying from few seconds to about a minute, depending on the
percentage of written records in the SIM phonebook. If Phonebook commands are issued
during this time the device returns an error message. If this happens, retry the operations later.
NOTE: Due to the particular features of the FD storage, when selecting the FD storage, the
PIN2 must have been inserted or the FD facility must have been enabled.
If +CPBS command reports +CME ERROR: 17 then enable the facility with command +CLCK
(see par. 3.1.1.2)
For example:
1- Let's assume you want to select the "SM" normal phonebook for operations,
command:
AT+CPBS="SM"<cr>
response
OK
2- Let's assume you want to select the "MC" missed calls list for operations,
command:
AT+CPBS="MC"<cr>
response
OK
3.1.1.2 Enable Fixed Dialing Phonebook facility (only for FD PB)
• Send command
AT+CLCK=FD,1,<PIN2><cr>
where:
<PIN2> is the PIN2 code of the SIM.
• wait for response:
Response Reason Action
OK FD facility is now enabled Return to select PB (see par.
3.1.1.1)
ERROR some error occurred Enable extended result codes
(see par. 2.5.2.1), check if the
PIN2 is correct
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 32 of 109