Telit Wireless Solutions GE863 - Manual (Page 58)

GE863-GPS Software User Guide
1vv0300724 Rev. 2 - 24/01/07
<pag> - page number
<pags> - total number of pages of the message
<data> - CBM Content of Message
<ds> - SMS-STATUS-REPORTs reporting option
0 - status report receiving is not reported to the DTE
1 - the status report is sent to the DTE with the following unsolicited result code:
(PDU Mode)
+CDS: <length><CR><LF><PDU>
where:
<length> - PDU length
<PDU> - message PDU
(TEXT Mode)
+CDS: <fo>,<mr>,,,<scts>,<dt>,<st>
where:
<fo> - first octet of the message PDU
<mr> - message reference number
<scts> - arrival time of the message to the SC
<dt> - sending time of the message
<st> - message status as coded in the PDU
2 - if a status report is stored, then the following unsolicited result code is sent:
+CDSI: <memr>,<index>
where:
<memr> - memory storage where the new message is stored
"SM"
<index> - location on the memory where SM is stored
<bfr> - buffered result codes handling method:
0 - TA buffer of unsolicited result codes defined within this command is flushed to the TE when
<mode>=1..3 is entered (OK response shall be given before flushing the codes)
1 - TA buffer of unsolicited result codes defined within this command is cleared when <mode>=1..3
is entered.
NOTE: issuing AT+CNMI<CR> is the same as issuing the Read command.
NOTE: issuing AT+CNMI=<CR> is the same as issuing the command AT+CNMI=0<CR>.
• wait
for
OK
TIP: In this command description the values that are always 0 are parameter reserved for future
use, in the current software revision the only value supported is 0.
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 58 of 109