Telit Wireless Solutions GE863 - Manual (Page 53)

GE863-GPS Software User Guide
1vv0300724 Rev. 2 - 24/01/07
Response Reason Action
OK The power save is now active
ERROR some error occurred Enable extended result codes
(see par. 2.5.2.1), and retry.
+CME ERROR: 4 operation not supported Check command syntax and
<fun> value.
TIP: The power saving function is disabled by default when the device starts up, in order to
guarantee that even without the DTR line support it is possible to exchange commands with
the module; for this reason the power saving setting command shall be issued after every
power up.
NOTE: The power saving for GSM part will not be activated if the GPS part is switched on.
The DTR functionality is usable only when +CFUN=5 is selected.
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 53 of 109