Topcom CALLMASTER 220 - Manual (Page 8)

Callmaster 220
8
1. Installation
- Plug one end of the phone cable into the telephone line wall socket
and the other end into the back of the unit “LINE” (1). To do this,
you may need to disconnect your telephone line cord from your
telephone set!
- Connect one end of the supplied phone cable to the telephone and
the other end to the back of the Callmaster 220 “PHONE” (2).
- Plug one end of the adapter into the electric socket and the other
end into the back of the phone (3).
- In case there are no electric sockets available, you can also use
batteries instead of an adapter.
- Open the battery compartment at the bottom of the unit.
- Insert 6 AAA batteries (1,5V).
- Close the battery compartment.
Note (1) : The battery low icon appears on the display when the battery is
almost empty or when you are using an adapter only. As soon as you have
replaced the empty batteries with new ones, the icon disappears.
Note (2) : During power failure, only the entries in the Phone Book will be kept!
PHONE LINE DC 9V
OFF LO HI
1 To Telephone line outlet
3
2
HANDL CALLM 220_SCAN 13/3/02 4:42 pm Page 8