Texas Instruments SLOU023A - Manual (Page 11)

2-1 Quick Start
Quick Start
The steps in this chapter can be followed to quickly prepare the TPA112 MSOP
audio amplifier EVM for use. Using the TPA112 MSOP EVM with the TI
plug-n-play audio amplifier evaluation platform is a quick and easy way to
connect power, signal and control inputs, and signal outputs to the EVM using
standard connectors. However, the audio amplifier evaluation module can be
used stand-alone by making connections directly to the module pins, and can
be wired directly into existing circuits or equipment.
The platform switch and jumper settings shown in Table 2–1 are typical for the
TPA112 MSOP EVM.
Table 2–1. Typical TI Plug-N-Play Platform Jumper and Switch Settings for the
TPA112 MSOP EVM
EVM JP6 JP7 JP8 S2 S3
TPA112 X X X Note 2 U5
Notes: 1) X = Don’t care
2) Set S2 to ON when signal conditioning board is installed in U1; set S2
to OFF when no signal conditioning board is installed.
Topic Page
2.1 Precautions 2–2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2.2 Quick Start List for Platform 2–3 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2.3 Quick Start List for Stand-Alone 2–4 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Chapter 2