Turbosound LMS-D6 - Manual (Page 20)

user manual
TA-890
TA-890 user manual
Page 20
Designing a system
To design a system begin by defining the venue/audience areas by clicking on the “Audience
Area” tab in the bottom left of the screen.
Within this window you can edit or remove existing audience areas, and create new ones.
There are two methods of defining an audience area. In either case you must define the
X1/Y1 coordinate of the start of the area, you can then either enter the X2/Y2 points or its
length and angle.
As you create audience areas they are shown graphically in the main window.
The next step is to design the loudspeaker array using the “System Setup” window. Select
the “System Setup” tab in the bottom left of the screen and begin by choosing the desired
flybar or groundstack in the drop down box at the top left of the window.