Turbosound LMS-D6 - Manual (Page 86)

user manual
TA-890
TA-890 user manual
Page 86
MAINTENANCE
If any of the drive units in your Aspect series cabinet should cease functioning and need to be
replaced or repaired, you are advised to remove the faulty unit from the cabinet and send it
to a professional service centre authorised to repair Turbosound loudspeakers.
This section covers the removal and replacement of the high frequency drivers and the high-
mid driver; and also the procedure to rotate the mid/high section from A (horizontal) to B
(vertical) mode, or vice versa.
It is easiest to work on the cabinet when it is placed on its back, either on the floor or on a
low workbench. The only tools required for maintenance are:
M5 Allen key
M4 Allen key
Two pairs of long nose pliers
13mm ring spanner or socket
The perforated loudspeaker grille and horn assembly are held in place by five M8
countersunk screws on the top, bottom and sides of the cabinet. Locate and undo these
screws using a 5mm hex key or power tool if available.