Toshiba Magnia Z300 - Manual (Page 176)

System Configuration Setup
SCSI Utility 154
c Host Adapter SCSI Termination : Enabled
Specifies whether the SCSI bus is to be terminated using the
SCSI host adapter. Do not change this setting.
c Boot Device Options
Specifies the SCSI device from which the system is to be
booted.
c Boot SCSI ID : 0
Selects the SCSI ID of the device which boots the system. Do
not change this setting.
c Boot LUN Number : 0
Selects the LUN of the device which boots the system. Do not
change this setting.
c SCSI Device Configuration
Specifies detailed configuration information for each SCSI
device (SCSI ID).
c Sync Transfer Rate (MB/Sec) : 160
Specifies the maximum synchronous transfer rate of the
onboard SCSI controller.
c Initiate Wide Negotiation : Yes
Set this item to Yes to specify Wide SCSI (16 bit data width).
c Enable Disconnection : Yes
Set this item to Yes to make the adapter activate the disconnect/
reconnect function and permit multiple-command processing.
c Send Start Unit Command : Yes
Specifies whether a start unit command is to be sent from the
adapter to start the SCSI device.
c
Enable Write-Back Cache : N/C
Specifies whether to use the write-back cache.
c BIOS Multiple LUN Support : No