Toshiba DKT2304-CT - Manual (Page 26)

Installation
Step 2: Select Location
16
Strata CIX and CTX DKT2204-CT/DKT2304-CT Cordless Digital Telephones
Step 2: Select Location
1. Select a location that is not subject to excessive heat or humidity. Keep the base
unit and handset away from sources of electrical noise, such as motors and
fluorescent lighting.
2. Determine if the base unit will sit on your desk or be wall mounted. If wall
mounted, go to Step 6: “(Optional) Wall Installation” on page 19 .
3. Place the base unit on a desk or tabletop near a standard 120VAC outlet and within
reach of the Strata CTX digital line connection.
Important! Place the base unit to the right of the DKT. If placed on the left, the
cordless antenna picks up a tone due to its close proximity to the DKT
speaker and electronic parts.
Step 3: Place DKT3000-series Telephones
into 2000-Mode
You must place your DKT3000-series telephone into 2000-mode before connecting
the cordless telephone; otherwise, the 3000-series telephone will not work.
In 2000-mode, the DKT3000 telephone operation changes are:
• Only 16 characters by two lines display on the LCD.
• LCD Feature button does not work
•
Spdial
button does not work
➤ To change DKT3000-series telephones into 2000-mode
1. On the DKT3000 telephone, press
3
+
6
+
9
+
Hold
(simultaneously).
2. Press
#
.
3. Press
FB7
(or
FB10
on the DKT3014). LED On = 2000 mode. LED Off = 3000
mode.
Note Flexible Buttons (FB) are numbered from the bottom up and left to right.
FB7
for example would be the seventh button up on the left.
4. Press
Hold
.
5. Lift the handset to exit programming mode. Wait a few seconds for the telephone
to reset itself.