Top Innovations SP-350 - Manual (Page 6)

STEAMER ASSEMBLY
STEP 1 -ATTACHING THE ROD
A. Set the appliance on a steady surface.
B. The Rod is shipped in a collapsed position and
must be extended for use. Take the Rod and
loosen the Top Knurled Knob slightly by
rotating it counter-clockwise. Grab the
Rod by
the Hook Mount and extend fully (about 18
inches). Tighten the Top Knurled Knob.
Similarly loosen the Bottom Knurled Knob and
extend the middle section of the Rod and
retighten.
D. Loosen the Rod Base by turning it counter
clockwise several turns. Insert the bottom of the
Rod and press down firmly. Hand-tighten the
Rod Base by turning clockwise.
Place the Dual Hook Hanger over the Hook
Mount and hand-tighten with clockwise turns.
C.
E.
STEP 2 -ATTACHING THE STEAMER HOSE
A. Screw the end of the steamer hose with the
knurled knob onto the threaded pipe on the
t o p of the steamer unit. (Caution: Do not use
excessive force in tightening the knob )
B. Tighten by hand until it no longer turns.
C. Hang the nozzle from the large hook on the
Dual Hook Hanger.
P.5