Trimble Outdoors 132 - Manual (Page 68)

5 Configuring the Receiver
6 8 DSM 132/132RS Receiver User Guide
Thales reference stations
To manually select a Thales network reference station:
1. From the DGPS Config screen, press 2 until the Thales Stn
screen appears:
2. Press 3 to activate the cursor.
3. Press 2 until Use Manual Mode appears.
4. Press 4 to save the changes.
5. Press 2 until Thales Man Stns appears:
6. Press 3 to activate the cursor.
7. Press 2 until the correct station appears for the satellite beam
you are using. Trimble strongly recommends the stations listed
below.
Note – Before you can select a reference station, you must have
a current subscription to the Thales DGPS service.
8. Press 4 to save the changes.
If you are using the
satellite beam ... with this
frequency ... select this
reference station ...
North American West 1556.255 565
North American Mountain 1554.350 555
North American East 1553.345 555
åæ Thales Stns
Use Network Stn
åæThales Man Stn
565 No access