Waas/egnos – Trimble Outdoors 132 User Manual
Page 69
DSM 132/132RS Receiver User Guide 6 9
Configuring the Receiver 5
5.1
WAAS/EGNOS
WAAS/EGNOS is a free satellite-based DGPS service that is available
only in North America (WAAS) or Europe (EGNOS). To use the
WAAS/EGNOS DGPS signal, you must first configure the receiver.
To configure the receiver to use WAAS/EGNOS DGPS:
1.
From the DGPS Config menu, press
2 until the DGPS Source
screen appears.
2.
Press
3 to activate the cursor.
3.
Press
2 until WAAS/EGNOS ONLY appears:
4.
Press
4 to save the changes.
To enable the WAAS/EGNOS DGPS signal:
1.
Press
2 until the WAAS/EGNOS T2 Remap screen appears.
2.
Press
3 to activate the cursor.
3.
Press
2 until On appears:
4.
Press
4 to save the changes.
To enable WAAS reception in the field:
1.
Take the receiver outside. Make sure that it has a clear southeast
and southwest view of the sky.
2.
Switch on the receiver.
WAAS activation can take two or more minutes.
åæ DGPS Source
WAAS/EGNOS ONLY
åæ WAAS/EGNOS
T2 Remap On