Toshiba TEC H-9000 - Manual (Page 29)

9. PROGRAMMING PROCEDURES
9.3 INGREDIENT MESSAGE
9- 7
9.3 INGREDIENT MESSAGE
Menu Page: 1
Item No.:
2
Ingredient messages can be printed on a label with a maximum of 54 characters per line using small
letters or 32 characters per line using boldfaced small letters. Will print up to 38 lines.
NOTES: 1. When no data is programmed for the PLU, ingredient cannot be set.
2. When a selected PLU is not stored in the PLU file, a PLU NOT FOUND error occurs.
3. Once you exit this menu and enter again, data stored in the work buffer is cleared.
4. When there is no area to store ingredient data, a
MEMORY FULL error occurs.
5. Different PLUs cannot use same the ingredient data. (PLU and ingredient data are in
pairs.)
Enter the PLU#
(max. 6 dig.)
<MENU>
Page 1
c
The memory file
is sorted when a
memory full error
occurs.
2
ENTER
Enter the ingredient message
(Refer to Page 9-3.)
Sorting
ENTER
TEST
PROG.
ESC.
<MENU>
Page 1
Main
<MENU>
Y
Not Sorting
NEXT
PLU
or
Pressing the key
calls data stored by pressing
the
key.
RECEIVE
SEND
Pressing the key
temporarily stores data into
the work buffer.
SEND
Any key
except Y