Toshiba TEC H-9000 - Manual (Page 63)

12. OPERATING PROCEDURES
NOTES BEFORE STARTING OPERATION
12- 1
12. OPERATING PROCEDURES
NOTES BEFORE STARTING OPERATION
How to access REG., M.DOWN, or REWRAP menu
<REG.> MANU. BY-COUNT
ENTER THE PLU #
(1) Insert the power plug into the AC outlet and turn the power ON.
(2) A sixteen-second scanning will be performed after pressing the
key.
(3) Do not move the unit while it is in operation. Should it become necessary to move it at
any time, turn the power switch to the OFF position and be sure to readjust the level
indicator after relocating the scale*.
(4) Should a power failure occur during operation, remove the commodity from the platter
and insert the power plug into an AC outlet again when power is restored.
(5) If the printer is used with an unrated power source, inaccurate scaling* or other errors
may occur.
(6) If the zero point has shifted during scaling, and no tare is displayed, adjust the zero point
by depressing the key*.
(7) Check the date of the printer before operation every day.
(8) Make a test print before operation every day.
Press the key, and the test label is issued.
*: Available only when the optional scale unit is connected.
ZERO
TEST
POWER
The following display is the REG. menu display. When this display is shown after pressing
the
key, you can start the REG. operation right away. POWER
NOTE: If a label nothing is printed or is issued after a printed label in batch mode, refer to
Section 9.11 and press the key. SET NEXT
To access a menu from other menus, press the key to show the Main menu and
enter the menu No. When the M.DOWN and REWRAP menus are protected, enter the
menu No. and then the password.
<Menu> MAIN
0. PROG.
5. READ
1. REG. 6. RESET
2. MARK DOWN 7.
3. REWRAP 8.
4. SECURITY 9.
ESC.
lb UNIT/$ TOTAL $
- - - - - P 000000