Toshiba B-SX600 SERIES - Manual (Page 34)

4- 1
4. LOADING THE RIBBON
This section describes how to load the ribbon when performing thermal transfer printing.
Precaution
Do not load a ribbon when using direct thermal media.
1. Open the Side Cover completely.
2. Push up the Upper Unit Unlock Lever to
unlock the Upper Unit. Hold and lift the
Upper Unit Handle until it is locked.
Ribbon Shaft (Supply side)
Ribbon Shaft (Take-up side)
Upper Unit
Upper Unit Unlock
Lever
CAUTION!
Be careful not to touch the Print Head Element while loading the ribbon.
Failure to do this may cause missing dots by static electricity or other print quality problems.
1. Do not touch any moving parts. To reduce the risk of fingers, jewellery, clothing, etc., being
drawn into the moving parts, be sure to load the ribbon once the printer has stopped moving
completely.
2. The print head becomes hot immediately after printing. Allow it to cool before loading the
ribbon.
3. To avoid injury, be careful not to trap your fingers while opening or closing the cover.
WARNING!