Toshiba B-SX600 SERIES - Manual (Page 42)

5. LOADING THE MEDIA
5- 5
5.2 How to Load the Media for the Model with the Peel-off Unit
* Please read section 5.1 How to Load the Media first.
* If the label in use is too long, place the printer where a printed label is not stuck to the printer or
the table.
1. Press the Front Cover Unlock button and open the
Front Cover.
2. Refer to Section 5.1 How to Load the Media and load the media. Place the leading edge of
the label 5 - 10 mm behind the leading edge of the strip plate.
[Supplemental Remarks]
Be sure to place the leading edge of a label within this range. Failure to do this may cause a
feed error.
Leading edge of label
Leading edge of Strip Plate
5 to 10 mm
Front Cover Unlock Button