Trimble Outdoors AgGPS 252 - Manual (Page 3)

OF THE POSSIBILITY OF ANY SUCH LOSS AND REGARDLESS OF
THE COURSE OF DEALING WHICH DEVELOPS OR HAS
DEVELOPED BETWEEN YOU AND TRIMBLE . B ECAUSE SOME
STATES AND JURISDICTIONS DO NOT ALLOW THE EXCLUSION
OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR
INCIDENTAL DAMAGES , THE ABOVE LIMITATION MAY NOT
APPLY TO YOU .
NOTE : THE ABOVE LIMITED WARRANTY PROVISIONS MAY
NOT APPLY TO PRODUCTS OR SOFTWARE PURCHASED IN THE
EUROPEAN UNION . PLEASE CONTACT YOUR TRIMBLE
DEALER FOR APPLICABLE WARRANTY INFORMATION .
Notices
USA
NOTE – FCC Part 15 rules; paragraph 15.105
This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a
residential area is likely to cause harmful interference, in
which case, you, the user, will be required to correct the
interference at your own expense.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and the
receiver.
– Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician
for help.
Changes and modifications not expressly approved by the
manufacturer or registrant of this equipment can void your
authority to operate this equipment under Federal
Communications Commission rules.
Europe
This product has been tested and found to comply with the
requirements for the European Directive 75/322/EEC as
amended by 2000/2/EC thereby satisfying the requirements
for e-mark compliance for use in agricultural vehicles in the
European Economic Area (EEA).
This product has been tested and found to comply with the
requirements for a Class A device pursuant to European
Council Directive 89/336/EEC on EMC, thereby satisfying the
requirements for CE Marking and sale within the European
Economic Area (EEA).
C Warning –
This is a Class A product. In a
domestic environment this product may cause
radio interference in which case you may be
required to take adequate measures.
Notice to Our European Union Customers
For product recycling instructions and more information,
please go to www.trimble.com/environment/summary.html.
Recycling in Europe:
To recycle Trimble WEEE (Waste
Electrical and Electronic Equipment,
products that run on electrical power.),
Call +31 497 53 24 30, and ask for the
"WEEE Associate".
Or, mail a request for recycling
instructions to:
Trimble Europe BV
c/o Menlo Worldwide Logistics
Meerheide 45
5521 DZ Eersel, NL
Declaration of Conformity
This product conforms to the following standards, and therefore complies with the requirements of the R&TTE
Directive 1999/5/EC, which specifies compliance with the essential requirements of EMC Directive 89/336/EEC and
Low Voltage Directive 73/23/EEC.
The technical file is maintained at Trimble Navigation Limited, 749 North Mary Avenue, PO Box 3642, Sunnyvale, CA
94088-3642, USA.
EMC Emissions BSEN 55022:1998 (W/A1:00) Class A
EMC Immunity EN 55024:1998
Safety EN 60950:2000
Mark First Applied 03
Ag252_100B_UserGuide_ENG.book Page iii Thursday, July 28, 2005 4:06 PM