Trimble Outdoors AgGPS 252 - Manual (Page 36)

4 Configuring the Receiver
3 0 AgGPS 252 Receiver User Guide
– serial number
– satellite beam name
OmniSTAR will activate the receiver. Activation can take
5–30 minutes.
40.1
WAAS/EGNOS
WAAS is a free satellite-based DGPS service that is available only in
North America; EGNOS is a free satellite-based DGPS service that is
available only in Europe.
To use the WAAS/EGNOS DGPS signal, you must first configure the
receiver.
1. Connect the AgGPS 252 receiver to the computer. Turn on the
receiver and start the AgRemote utility.
2. In AgRemote, select Configuration / DGPS Config.
3. Set the Source Select field to WAAS.
4. Press 4 then 5 to complete the procedure.
To enable WAAS reception in the field:
1. Take the receiver outside. Make sure that it has a clear southeast
and southwest view of the sky.
2. Turn on the receiver. WAAS activation can take two or more
minutes. Once activation succeeds, the Home screen displays
D/3D .
Ag252_100B_UserGuide_ENG.book Page 30 Thursday, July 28, 2005 4:06 PM