Tascam BD-R2000 - Manual (Page 16)

16
Getting Started
Name and Function of
Parts (Continued)
g
[ N ]
Fast forwards the video and starts slow playback.
h
[ I ]
Plays the video.
i
[ W ]
Pauses the video that is currently playing.
j
[ o ]
Stops playback/recording.
k
[MARK]
Adds a chapter mark during playback or recording. Select
multiple titles from the playback navigation screen or other
screens.
l
[PB MODE]
Display the playback settings screen.
m
[ANGLE]
Switches the camera angle for playback.
n
[SET UP]
Displays the settings menu screen.
o
[SUB TITLE]
Switches the playback subtitle.
p
[INFORMATION CORRECT]
Displays the information editing screen.
Change batteries for the remote control
• If the operable distance of the remote control unit becomes
shorter, this means that the batteries are running out.
When this occurs, replace the batteries with new ones.
Batteries
• Insert the batteries correctly according to the + and - signs.
Insert the - side of the battery first.
• If an error occurs while using the remote control unit,
remove the batteries, wait for about five minutes, and
operate the remote control unit again after re-inserting the
batteries.
Battery life : Approximately 6 months
(depending on the frequency of use)
Remote control codes
By setting a remote control code for the unit and remote
control, you can prevent two recorders from operating
simultaneously using the remote control for this unit.
(the setting for the unit and remote control at time of purchase
is “REMOTE CONTROL 3”.)
Memo:
• Changing the remote control code for the remote control
before the unit’s remote control code is changed will cause
the unit to be inoperable. Change the unit’s remote control
code first when changing remote control codes.
o
Changing the remote control code for the
unit
1 Press the [SET UP] button on the remote control
to display the “SETUP” menu
2 Change the “REMOTE CONTROL CODE” option
in the “SETUP” menu
Memo:
• For more details, refer to “REMOTE CONTROL CODE” (A
page 75).
o
Changing the remote control code for the
remote control
1 Press and hold the [OPTIONS] button on the
remote control
2 Press either of the [1], [2], [3] or [4] buttons
• Press the number button that is equivalent to the remote
control code you desire.
3 Press the [OK] button
• Press the [OK] button to change the remote control code.
4 Release the [OPTIONS] button on the remote
control
Memo:
• If the remote control code is different from the unit, the
remote control code for the unit will be displayed on the
display window.
Examples: REMOTE CONTROL 3