Tascam BD-R2000 - Manual (Page 4)

4
Safety Precaution
0 Manufactured under license from Dolby Laboratories.Dolby and
the double-D symbol are trademarks of Dolby Laboratories.
0 Manufactured under license under U.S. Patent #'s: 5,451,942;
5,956,674; 5,974,380; 5,978,762; 6,226,616; 6,487,535; 7,392,195;
7,272,567; 7,333,929; 7,212,872 & other U.S. and worldwide
patents issued & pending. DTS and the Symbol are registered
trademarks, & DTS-HD, DTS-HD Master Audio | Essential and the
DTS logos are trademarks of DTS, Inc. Product includes software.
© DTS, Inc. All Rights Reserved.
0 This product incorporates copyright protection technology that is
protected by U.S. patents and other intellectual property rights.
Use of this copyright protection technology must be authorized
by Rovi Corporation, and is intended for home and other
limited viewing uses only unless otherwise authorized by Rovi
Corporation. Reverse engineering or disassembly is prohibited.
0 DVD logo is a trademark of DVD Format/Logo Licensing Corporation.
0 HDMI, the HDMI logo and High-Definition Multimedia Interface are
trademarks or registered trademarks of HDMI Licensing LLC in the
United States and other countries.
0
“Blu-ray Disc”, “Blu-ray” and “Blu-ray Disc” logo are trademarks of
Blu-ray Disc Association.
0 “x.v.Color” and the “x.v.Color” logo are trademarks of Sony Corporation.
0 Java and all Java-based trademarks and logos are trademarks
or registered trademarks of Sun Microsystems, Inc. in the United
States and other countries.
0 SDHC Logo is a trademark of SD-3C, LLC.
0 i.LINK and the "i.LINK" Logo are trademarks.
0 “AVCHD” and the “AVCHD” logo are trademarks of Panasonic
Corporation and Sony Corporation.
0 Other product and company names included in this instruction
manual are trademarks and/or registered trademarks of
theirrespective holders.
0
This product is licensed under the AVC patent portfolio
license and VC-1 patent portfolio license for the personal
and noncommercial use of a consumer to (i) encode video
in compliance with the AVC Standard and VC-1 Standard
(“AVC/VC-1 Video”) and/or (ii) decode AVC/VC-1 Video that
was encoded by a consumer engaged in a personal and non-
commercial activity and/or was obtained from a video provider
licensed to provide AVC/VC-1 Video. No license is granted or
shall be implied for any other use. Additional information may
be obtained from MPEG LA, LLC. See http://www.mpegla.com.
Batteries -- Incorrect use of batteries may cause the batteries
to burst or ignite. A leaky battery may corrode the equipment,
dirty your hands or spoil your clothing. In order to avoid these
problems, make sure to observe the precautions below:
0
Use the specified batteries only.
0 Install the batteries with due attention to the plus (+) and minus
(-) sides of the batteries according to the instructions in the
compartment.
0 Do not mix old and new batteries.
0 Do not mix batteries of different types. Voltage specifications of
batteries of the same shape may vary.
0
Replace an exhausted battery with a new one promptly.
0
If you will not use the remote control for a long time, remove the
batteries.
0
If leaked battery fluid gets on your skin or clothing,
rinseimmediately and thoroughly. If it gets into you eye, bathe
your eye well rather than rubbing and seek medical treatment
immediately. Leaked battery fluid that gets into your eye or your
clothing may cause a skin irritation or damage your eye.
0 Do not put the batteries in a place where young children can
reach.
ATTENTION:
Using a mobile phone in the vicinity of the unit may cause picture
vibration on the TV screen or change the screen to a black back
display.
Some TVs or other appliances generate strong magnetic fields.
Do not place such appliances on top of the unit as it may cause
picture disturbance.
When moving the product, press A to turn off the power, and
wait at least 30 seconds before unplugging the power cord.
Then, wait at least 2 minutes before moving the product.
If there is a power outage when using the unit, the recorded data
may be erased.
It is recommended to back up discs which contain important
recordings periodically (every few years). As digital signals do
not deteriorate, failure to play back or record might arise due to
the effects of the disc aging through the years depending on the
storage environment.
Recorded programs and data cannot be restored once the disc
or tape is damaged.
DISCLAIMER OF LIABILITY
TASCAM shall not be liable for any loss relating to the unit’s failure
to properly record, store or playback any content (video, audio or
otherwise) for any reason whatsoever. Any applicable warranties
shall only cover replacement or repair of the effected unit, and shall
not apply to recovery or replacement of lost content.
0 This unit can play back and record only NTSC signals.
The hard disk is a consumable item. Replacement is
recommended after 10000 hours of use (if use in a 25°C
environment). For information on maintenance planning and
costs, consult your nearest TASCAM dealer.
The fan motor is a consumable item. Replacement is
recommended after 30000 hours of use (if use in a 25°C
environment). For information on maintenance planning
and costs, consult your nearest TASCAM dealer.
HOW TO USE THIS INSTRUCTION MANUAL
0
All major sections and subsections are listed in the Table Of
Contents on page 5. Use this when searching for information on a
specific procedure or feature.
0 The A mark signals a reference to another page for instructions or
related information.
0 Operation buttons necessary for the various procedures are clearly
indicated through the use of illustrations at the beginning of each
major section.
If this symbol is shown, it is only valid in the European
Union.
IMPORTANT:
0
Please read the various precautions on page 2 to 4 before installing
or operating the unit.
0 It should be noted that it may be unlawful to re-record prerecorded
tapes or discs without the consent of the owner of copyright in the
sound or video recording, broadcast or cable programme and in
any literary, dramatic, musical, or artistic work embodied therein.