TransAct Technologies ITHERM 280 User Manual
Page 169
iTherm
®
280 Programmer’s Guide
Programming Codes
28-07764
Rev C
Page 167
[ESC] y
Set control feature commands
ASCII
[ESC] y <n>
Hexadecimal 1BH 79H <n>
Decimal
<27> <121> <n>
IPCL
&%Y0-9 or &%YX <m
1
> <m
2
> <m
3
> (for numbers greater than nine)
EPOS
[ESC] y <n>
Where n
0
Reinitializes the printer and forces Citizen mode
1
Reinitializes the printer and forces Star mode
2
Reinitializes the printer and forces iTherm® 280 mode
3
Reinitializes the printer and forces extended EPOS mode
4
Disables IPCL commands
5
Enables IPCL commands
6
Disables inquire processing (All command preprocessing is
disabled.)
7
Enables inquire processing
8
Enables extended diagnostics
9
Print Current Configuration
10
Not used
11
Overlays the current character chart with Group 2 OCR MA
Characters
12
Replaces the OCR characters with normal characters
13
Not used
14
Forces head maintenance
15
Print Current totals
16
Enable Test Font
17
Requests the printer to enter remote OFF.
18
Requests the printer to exit remote OFF.
20
Print alignment settings
Description The [ESC] y <n> command enables and disables command set features.
It is possible that the IPCL commands will interfere with print data. If this
occurs, the IPCL can be disabled with an [ESC] y <4> command.
Note 1: Once IPCL commands are disabled, the Enable IPLC command
will not be a valid IPCL code.
Note 2: [ESC] y <0>, <1>, <2>, and <3> allow the printer to switch
between emulation modes. When the switch takes place, the current print
buffer is printed, and the printer reinitializes. These commands do not
permanently change the configuration. A power on reset restores the
mode that was configured in menu mode. A reset by command or from
the INIT pin does not restore the mode.