TransAct Technologies ITHERM 280 - Manual (Page 24)

Specifications and Requirements iTherm ® 280 Programmer’s Guide
Page 22 Rev C 28-07764
•
CPI selections from 8 to 30 CPI
1
•
Paper Out sensor
•
Multiple printer emulations: Ithaca PcOS and Epson Extended,
•
Maximum 8K buffer (adjustable)
•
2 Megabytes Flash Memory
•
2 Megabytes RAM
•
APA and Epson graphics
•
Bar Codes: Code 39, Code 93, Code 128, Interleaved 2 of 5, UPC-A, UPC-
E, EAN-8, EAN-13, EAN-14, PDF417 stacked symbology and Codabar
•
WGL4.0 Character set.
•
Metal receipt tear off
•
8 dots/mm. thermal print head resolution
•
ON/OFF button located on front of printer
•
Cable routing strain relief
•
Power/Error/Paper LEDs
•
Paper feed button
•
Cover open button
•
Settable cash drawer configurations (Ithaca, Epson, or Star)
•
Spill proof design- vertical main PCB mounting
•
58 mm. or 80 mm. paper width – factory-settable
•
4.0 inch (101 mm.) Paper roll diameter
•
Portrait/landscape printing under Windows
•
Page mode printing
•
Cover Open sensor
•
Electronic journal capability
•
Internal counters for hours on, cuts, print lines and errors
•
100 km print head life
•
60 million print line printer MCBF (excluding knife)
•
Strong break-away paper cover
•
1,000,000 cuts cutter life (partial cut)
•
Buzzer
•
2 color printing (4 inches per second print speed)
1 Character spacing is adjustable from 1 to 30 CPI. Typical values will be between 8 and 20 CPI
depending on the font selected. Values of 13.3, 14.86, or 17.3 are typical for each resident font.
2
CPI’s greater than 16 will not be supported in NLQ fonts