Taylor 161 - Manual (Page 13)

9 Model 161 Important: To the Operator
If the beater motor is turning properly, press the WASH
key to cancel the cycle. Press the AUTO key on both
sides of the unit to resume normal operation. If the
freezer shuts down again, contact a service
technician.
Air Tube
The air tube serves two purposes. One end of the tube
has an orifice (hole) and the other end does not.
Figure 1
1. After priming the machine, place the orifice end
of the air tube into the mix inlet hole. Every time
the draw handle is raised, new mix and air from
the hopper will flow down into the freezing
cylinder. This will keep the freezing cylinder
properly loaded and will maintain overrun.
2. During long “No Sale” periods, remove the air
tube. Replace the air tube with the (end without
hole), into the mix inlet hole. This will prevent
any mix from entering the freezing cylinder.
The air tube maintains overrun and allows
enough mix to enter the freezing cylinder after a
draw.