Toshiba RD-XS30B - Manual (Page 42)

42
TOSHIBA RD-XS30B Ope
Tips on recording (continued)
Basic operations
To delay the end time while executing a
programmed recording
Press the EXTEND button under the lid of the
remote control.
When you press it once, the current end time appears.
Each time you press the button, the end time
(displayed in the front panel display) is delayed in 10
minutes increments, up to 60 minutes.
Notes
• Pressing any button other than the EXTEND button
completes this procedure to determine the end time.
• This operation must be performed prior to 1 minute before
the programmed end time.
• A recording automatically finishes when the disc is full or
when the recording exceeds 8 hours regardless of whether
or not you delayed the end time.
To play a title recorded on the HDD while
recording on the HDD (Recorded Title Play in
HDD)
HDD
This function works only during HDD recording.
You cannot play a title recorded on a DVD-RAM disc
simultaneously with DVD-RAM recording.
1) While recording on the HDD, press the
CONTENT MENU button.
2) Press the / / / buttons to select a
desired title, then press the ENTER button.
Playback of the selected title starts.
Pressing the STOP button stops playback, and the
content that is being recorded appears on the
display. If you press the PLAY button, playback
resumes from the location you last stopped.
Notes
• While you are using this function, the following operations/
functions are not available.
- Programmed playback (Repeat playback, intro scan, etc.)
- Editing (Playlist programming, dubbing, title/chapter
naming, title thumbnail setting)
• While performing relay recording ( page 74), this
function is not available.
Entering the recording format on the DVD-R
When “DVD-R Broadcast Record” is set to “Off”, make
sure “NICAM” is set to “On” and “L-PCM” is selected
for sound.
To record broadcast programmes on DVD-R
When recording, make sure that “DVD-R Broadcast
Record” is set to “On” (
page 143).
For programmed recording, set “DVD-R Broadcast
Record” to “On” for each programmed recording.
(
page 38)
Notes
• You cannot close the disc tray automatically at the
recording start time. If you want to record on a DVD-RAM
disc, load it on the recorder beforehand.
• While recording, you cannot change the settings of a
programme, such as the channel, mode, etc.
• The number of titles cannot exceed in any case 99 for a
DVD-RAM and 198 for the HDD.
• You cannot record on both an HDD and a DVD-RAM disc
at the same time (except relay recording).
• The maximum length of a recording is 8 hours. Recording
automatically stops when length exceeds 8 hours.
• While performing a programmed recording, you cannot
programme a new entry.
• You may not be able to start recording if there is too little
time before a programmed recording begins.
• If a power failure occurs during a programmed recording, a
recorded content between the power failure and power
recovery is lost.
• If an HDD starts programmed recording while you are
playing a disc in the DVD drive, the picture may pause
momentarily.
• When you record monaural sound, the same sound is
recorded to both left and right channel.
• To select NICAM, set “NICAM” to “On” ( page 140).
• When you set “DVD-R Broadcast Record” to “Mode I ” or
“Mode II ” ( page 143), only the selected sound of the
bilingual programme (main or sub) is recorded. When
setting “DVD-R Broadcast Record” to “Off”, you need to
have set “NICAM” to “On”. (If the NICAM setting is “Off”, the
NICAM sound will not be recorded.)
RD-XS30B.Ope(US)p036-048 2/15/03, 2:57 AM 42