Toshiba MMK-AP0092H - Manual (Page 8)

5
3
INSTALLATION OF INDOOR UNIT
WARNING
Install the air conditioner certainly to sufficiently withstand the weight.
If the strength is insufficient, the unit may fall down resulting in human injury.
Perform a specified installation work to guard against strong wind or earthquake.
An incomplete installation can cause accidents by the units falling and dropping.
REQUIREMENT
Strictly comply with the following rules to prevent damage of the indoor units and human injury.
• Do not put a heavy article on the indoor unit. (Even units are packaged)
• Carry in the indoor unit as it is packaged if possible. If carrying in the indoor unit unpacked by necessity, be
sure to use buffering cloth, etc. to not damage the unit.
• To move the indoor unit, do not apply force to the refrigerant pipe, drain pan, foamed parts, or resin parts, etc.
• Carry the package by two or more persons, and do not bundle it with PP band at positions other than specified.
Remote controller
• A place where there are no obstacles such as a curtain that may block the signal from the indoor unit.
• Do not install the remote controller in a place exposed to direct sunlight or close to a heating source, such as a
stove.
• Keep the remote controller at least 1m apart from the nearest TV set or stereo equipment.
(This is necessary to prevent image distur-bances or noise interference.)
• The location of the remote controller should be determined as shown below.
Be careful to the following items when installing the unit.
• Considering air discharge direction, select an
installation place where discharge air can circulate
evenly in a room. Avoid to install the unit at place with
“NO GOOD” mark in the right figure.
5 m
5 m
45˚
45˚
75˚
* 7 m
7 m
(Top view)
Indoor unit
* : Axial distance
Reception
range
Reception range
Remote controller
Indoor unit
Remote controller
(Side view)
Screen
Good installation place
Cooled well all over.
Bad installation place
: Not cooled well.
OK NO GOOD
2
SELECTION OF INSTALLATION PLACE