Technicolor - Thomson 570 - Manual (Page 15)

1 SpeedTouch™570 Installation
3EC 17766 BAAA TCZZA Ed. 01 15
1.3.1. First-time Wireless Client Connectivity
Initial SpeedTouch™ 570
wireless configuration
When the SpeedTouch™570 leaves the factory and after every Push-to-Defaults, the
SpeedTouch™570 wireless configuration returns to its initial default settings.
These settings are as follows:
• The SSID is as printed on the identification label located on the bottom of your
SpeedTouch™570 .
• The DSSS radio channel number is set to “automatic”.
• The 'Registration' button is activated.
• The Access Control List is empty and locked.
• WEP encryption is disabled.
Preconditions for a
successful first-time
WLAN client
registration
Make sure that:
• The SpeedTouch™570 is powered on and ready for service.
• The SpeedTouch™570 is in its default configuration.
If needed, perform a push-to-defaults via its default button.
• The WLAN client adapter is installed on your computer.
By default the WLAN client adapter’s IP configuration is set to dynamically obtain
its IP configuration (DHCP).
• The WLAN client is correctly configured for the default SpeedTouch™570 SSID,
hence associated to the SpeedTouch™570 WLAN. Depending on your WLAN
client a wireless icon may become green or a message similar to the following may
pop up: “Successfully joined Wireless network SpeedTouch012345".
Note Some WLAN clients do not automatically join a WLAN. If so, follow the
instructions for the WLAN client software to initiate the association.
Registering the first
WLAN client
Proceed as follows:
Step Action
1 Make sure that all preconditions mentioned above are met.
2 Push the red Registration button on the SpeedTouch™570 back panel.
3 Make sure the WLAN client is correctly associated again to the Speed-
Touch™570 WLAN. Depending on your WLAN client adapter a wireless icon
may become green or a message similar to the following may pop up:
“Successfully joined Wireless network SpeedTouch012345".
Note Some WLAN clients do not automatically join a WLAN. If so,
follow the instructions for the WLAN client software to initiate
the association.
4 As a result the WLAN client is associated to the default SpeedTouch™570
Wireless environment and registered to the Access Control List.