Toshiba B-492L - Manual (Page 18)

2. PRINTER SETUP EO1-33032
2.7 Loading the Media
2- 7
2.7 Loading the Media
(Cont.)
3. Open the paper entry guide.
4. Loosen the locking screw of the right side of the media guide and
open the media guides.
5. Insert each edge of the media into the paper holders of the media
guides by adjusting the media guides positions to the media width.
Then tighten the locking screw.
6. Pass the media straight from the paper holders to paper outlet. The
media should be centred on the strip plate, otherwise skew feeding or
a paper jam may occur. Check that the media is positioned so that the
distances from the media edge to the end of the scale marked on the
strip plate (Distances A and B in the figure below.) are almost equal.
NOTE:
The media guide should be
positioned so that the media
can feed smoothly.
Paper Entry Guide
Locking Screw
Paper Holder
Media Guide
Loose
A B
Strip Plate
Media
Paper Holder
Distances A and B should
be almost equal.
Scale