Toshiba B-492L - Manual (Page 53)

APPENDIX 4 SYSTEM MODE EO1-33032
A4.3 Reset Mode
A4- 3
A4.3 Reset Mode
A4.4 Self-Diagnostic
Test
The Reset operation clears all the print data that has been sent to the
printer from the computer, and returns the printer to an idle condition.
1. The printer is on, standing by, or printing.
2.
To stop printing, or clear the data sent from the computer, press the
[PAUSE] key. The printer stops printing.
3. Press and hold the [RSTART] key for 3 seconds or longer.
4. Press [PAUSE] key. All data that has been received sent from the
computer will be cleared, and the printer returns to an idle condition.
The Self-Diagnostic Test contains the following sub menus:
21 /,1(
3$86( 
!5(6(7
21 /,1(
NOTE:
If the [RESTART] key is held for
less than 3 seconds when the
printer is in an error or pause
state, the printer will restart
printing. However, when a
communication error or
command error occurs, the
printer will return to an idle
condition.
[PAUSE]
[PAUSE]
[FEED]
[FEED]
[RESTART]
[RESTART]
[FEED]
Select the ribbon type
Print out the Maintenance Counter
and Parameter Settings.
Perform a Self-Diagnostic Test, and
prints out the result.
Check to see if there is any problem
with the print head.
!',$* 9[[
$872 ',$*1267,&
0$,17(1$1&( &217
+($' &+(&.
5,%%21 75$16
[RESTART]
Outline of Self-Diagnostic Test
In the Self-Diagnostic Test
mode
, the printer checks and
prints out the printer system
information such as the sensor
or interface, and the
Maintenance Counter.
It also
performs the print head
broken element check.
NOTE:
Use the [FEED] or [RESTART]
key to select a desired option.